Diagnosis Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK INTERMITTENT INCIDENT
Refer to "INTERMITTENT INCIDENT ".
Is the inspection result normal?
YES: Go to 2.
NO: Repair or replace damaged parts.
- DETECT MALFUNCTIONING ITEM
Disassemble the A/T assembly to check component parts. Refer to "DISASSEMBLY ".
NOTE: Check the component parts, referring to "Possible cause" in "DTC DETECTION LOGIC". Refer to "DTC LOGIC ".Is the inspection result normal?
YES: Replace control valve & TCM. Refer to "EXPLODED VIEW ".
NO: Repair or replace damaged parts.