DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.

CAUTION: Always drive vehicle at a safe speed.

PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

Go to 2.
CHECK DTC DETECTION
With CONSULT-III
1. Start the engine.
2. Select "SLCT LVR POSI" and "VHCL/S SE-A/T" in "Data Monitor" in "TRANSMISSION".
3. Drive vehicle and maintain the following conditions for 5 seconds or more.
  SLCT LVR POSI : D
  
  VHCL/S SE-A/T : More than 10 km/h (7 MPH)
4. Perform "Self Diagnostic Results" in "TRANSMISSION".
With GST

Follow the procedure "With CONSULT-III".

Is "P0725" detected?

YES: Go to "DIAGNOSIS PROCEDURE ".

NO: INSPECTION END