LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2011 >> G37 IPL, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 61 (Automatic Transmission -- G37 Coupe) >> DTC/Circuit Diagnosis >> DTC P0705: Transmission Range Switch A >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. PRECONDITIONING

    If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

    Go to 2.

  2. CHECK DTC DETECTION

    With CONSULT-III 

    1. Start the engine.
    2. Select "ACCELE POSI" and "VHCL/S SE-A/T" in "Data Monitor" in "TRANSMISSION".
    3. Shift the selector lever throughout the entire shift position from "P" to "D". (Hold the selector lever at each position for 2 seconds or more)
    4. Drive vehicle and maintain the following conditions for 2 seconds or more.

      ACCELE POSI : More than 1.0/8

      VHCL/S SE-A/T : 10 km/h (7 MPH) or more

    5. Perform "Self Diagnostic Results" in "TRANSMISSION".

    With GST 

    Follow the procedure "With CONSULT-III".

    Is "P0705" detected? 

    YES: Go to "DIAGNOSIS PROCEDURE ".

    NO: INSPECTION END

scientia non olet · About LEMON Manuals