DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
Go to 2.
- CHECK DTC DETECTION
With CONSULT-III
- Shift the selector lever to "P" and "N" positions.
- Turn ignition switch ON and wait 2 seconds or more.
- Perform "Self Diagnostic Results" in "TRANSMISSION".
Is "P0615" detected?
YES: Go to "DIAGNOSIS PROCEDURE ".
NO: INSPECTION END