DRIVER SIDE : Diagnosis Procedure

1. CHECK POWER WINDOW MAIN SWITCH OUTPUT SIGNAL
   1. Turn ignition switch OFF.
   2. Disconnect driver side power window motor connector.
   3. Turn ignition switch ON.
   4. Check voltage between driver side power window motor harness connector and ground.
   TERMINALS VOLTAGE REFERENCE CHART
   
   

   (+)		(-)	Condition		Voltage (V) (Approx.)
   Driver side power window motor
   Connector	Terminal
   D10	6	Ground	Power window main switch	UP	Battery voltage
   				DOWN	0
   	3			UP	0
   				DOWN	Battery voltage

   Is the measurement value within the specification? 

   YES: GO TO 2.

   NO: GO TO  3.

2. CHECK POWER WINDOW MOTOR

   Check driver side power window motor.

   Refer to "DRIVER SIDE : COMPONENT INSPECTION ".

   Is the inspection result normal? 

   YES: GO TO  4.

   NO: Replace driver side power window motor. Refer to "REMOVAL AND INSTALLATION ".

3. CHECK POWER WINDOW MOTOR CIRCUIT
   1. Turn ignition switch OFF.
   2. Disconnect power window main switch connector.
   3. Check continuity between power window main switch harness connector and driver side power window motor harness connector.
      TERMINALS CONTINUITY REFERENCE CHART
      
      

      Power window main switch		Driver side power window motor		Continuity
      Connector	Terminal	Connector	Terminal
      D8	8	D10	6	Existed
      	11		3

   4. Check continuity between power window main switch harness connector and ground.
   TERMINALS CONTINUITY REFERENCE CHART
   
   

   Power window main switch			Continuity
   Connector	Terminal
   D8	8	Ground	Not existed
   	11

   Is the inspection result normal? 

   YES: Replace power window main switch. Refer to "REMOVAL AND INSTALLATION ".

   NO: Repair or replace harness.

4. CHECK INTERMITTENT INCIDENT

Refer to "INTERMITTENT INCIDENT ".

INSPECTION END