Diagnosis Procedure

1. Turn ignition switch OFF.
2. Check signal between BCM harness connector and ground using oscilloscope.
   INSIDE KEY ANTENNA INPUT SIGNAL 1 REFERENCE CHART
   
   

   (+)			(-)	Condition	Signal (Reference value)
   BCM
   Connector		Terminal
   Console	M122	72, 73	Ground	Place Intelligent Key inside the vehicle.
   				Place Intelligent Key outside the vehicle.

   Is the inspection result normal? 

   YES: GO TO  4.

   NO: GO TO 2.

1. Disconnect BCM connector and inside key antenna (console) connector.
2. Check continuity between BCM harness connector and inside key antenna (console) harness connector.
   TERMINALS CONTINUITY REFERENCE CHART
   
   

   BCM		Inside key antenna (console)		Continuity
   Connector	Terminal	Connector	Terminal
   M122	72	M146	2	Existed
   	73		1

3. Check continuity between BCM harness connector and ground.
   TERMINALS CONTINUITY REFERENCE CHART
   
   

   BCM		Ground	Continuity
   Connector	Terminal
   M122	72		Not existed
   	73

   Is the inspection result normal? 

   YES: GO TO 3.

   NO: Repair or replace harness.

1. Replace inside key antenna (console). (New antenna or other antenna)
2. Connect BCM connector and inside key antenna (console) connector.
3. Check signal between BCM harness connector and ground using oscilloscope.
   INSIDE KEY ANTENNA INPUT SIGNAL 2 REFERENCE CHART
   
   

   (+)			(-)	Condition	Signal (Reference value)
   BCM
   Connector		Terminal
   Console	M122	72, 73	Ground	Place Intelligent Key inside the vehicle.
   				Place Intelligent Key outside the vehicle.

   Is the inspection result normal? 

   YES: Replace inside key antenna (console). Refer to "CONSOLE : REMOVAL AND INSTALLATION ".

   NO: Replace BCM. Refer to "REMOVAL AND INSTALLATION ".

Refer to "INTERMITTENT INCIDENT ".

INSPECTION END