AFS CONTROL UNIT : Diagnosis Procedure
- FUSE INSPECTION
Check that the following fuses are not fusing.
FUSE REFERENCE CHARTSignal name Connection position Fuse No. Capacity Ignition power supply FUSE BLOCK (J/B) 3 10 A Is the fuse fusing?
YES: Repair the applicable circuit. And then replace the fuse.
NO: GO TO 2.
- CHECK POWER SUPPLY CIRCUIT
- Turn the ignition switch OFF.
- Disconnect AFS control unit harness connector.
- Turn the ignition switch ON.
- Check voltage between AFS control unit harness connector and the ground.VOLTAGE REFERENCE CHART
Terminals Voltage (Approx.) (+) (-) AFS control unit Ground Connector Terminal M16 1 Battery voltage Is the measurement value normal?
YES: GO TO 3.
NO: Repair the harness or connector.
- CHECK GROUND CIRCUIT
- Turn the ignition switch OFF.
- Check continuity between AFS control unit harness connectors and the ground.CONTINUITY REFERENCE CHART
AFS control unit Ground Continuity Connector Terminal M16 25 Existed Does continuity exist?
YES: Repair the harness or connector.
NO: Power supply and ground circuit are normal.