LEVELIZER ADJUSTMENT : Special Repair Requirement

CHECK VEHICLE CONDITION
1. Park the vehicle in the straight-forward position.
2. Unload the vehicle (no passenger aboard).
  GO TO 2.
LEVELIZER ADJUSTMENT
CONSULT-III WORK SUPPORT
1. Select "LEVELIZER ADJUSTMENT" of ADAPTIVE LIGHT work support item.
2. Select "START".
3. When "ADJUSTMENT IS COMPLETED", select "END".
  CAUTION: If "CAN NOT BE TESTED" is indicated, AFS control unit detects that the height sensor signal changes. The levelizer adjustment is cancelled. In this case, turn the ignition switch OFF to prevent the vehicle from the height change. Perform the levelizer adjustment again.
  
  Is the levelizer adjustment completed?
  
  YES: GO TO 3.
  
  NO: Perform the levelizer adjustment again.
SELF-DIAGNOSIS RESULT CHECK
Perform self-diagnosis with CONSULT-III. Check that any DTC is not detected.

Is any DTC detected?

YES: GO TO 2.

NO: Levelizer adjustment completed