DTC Index
NOTE:
- The details of time display are as per the following.
- 0: The malfunctions that are detected now
CAN communication system (U1000, U1010)
- 1 - 39: It increases like 0 → 1 → 2... 38 → 39 after returning to the normal condition whenever the ignition switch OFF → ON. It returns to 0 when a malfunction is detected again in the process.
- If it is over 39, it is fixed to 39 until the self-diagnosis results are erased.
Other than CAN communication system (Other than U1000, U1010)
- 1 - 49: It increases like 0 → 1 → 2... 38 → 49 after returning to the normal condition whenever the ignition switch OFF → ON. It returns to 0 when a malfunction is detected again in the process.
- If it is over 49, it is fixed to 49 until the self-diagnosis results are erased.
DTC FAIL-SAFE FUNCTION CHART
| x: Applicable | |||||||
|---|---|---|---|---|---|---|---|
| DTC | CONSULT-III display | ICC system warning lamp | Fail-safe function | Reference | |||
| CONSULT-III | On board display | Vehicle-to-vehicle distance control mode | Conventional (fixed speed) cruise control mode | Brake Assist (with Preview Function) | |||
| C1A00 | 0 | CONTROL UNIT | x | x | x | x | |
| C1A01 | 1 | POWER SUPPLY CIR | x | x | x | x | |
| C1A02 | 2 | POWER SUPPLY CIR 2 | x | x | x | x | |
| C1A03 | 3 | VHCL SPEED SE CIRC | x | x | x | x | |
| C1A04 | 4 | ABS/TCS/VDC CIRC | x | x | x | x | |
| C1A05 | 5 | BRAKE SW/STOP L SW | x | x | x | x | |
| C1A06 | 6 | OPERATION SW CIRC | x | x | x | ||
| C1A12 | 12 | LASER BEAM OFFCNTR | x | x | x | ||
| C1A13 | 13 | STOP LAMP RLY FIX | x | x | x | ||
| C1A14 | 14 | ECM CIRCUIT | x | x | x | x | |
| C1A15 | 15 | GEAR POSITION | x | x | x | ||
| C1A16 | 16 | RADAR STAIN | x | x | x | ||
| C1A18 | 18 | LASER AIMING INCMP | x | x | x | ||
| C1A21 | 21 | UNIT HIGH TEMP | x | x | x | x | |
| C1A24 | 24 | NP RANGE | x | x | x | x | |
| C1A26 | 26 | ECD MODE MALF | x | x | x | x | |
| C1A27 | 27 | ECD PWR SUPLY CIR | x | x | x | x | |
| C1A33 | 33 | CAN TRANSMISSION ERROR | x | x | x | x | |
| C1A34 | 34 | COMMAND ERROR | x | x | x | x | |
| NO DTC IS DETECTED. FURTHER TESTING MAY BE REQUIRED | 55 | NO DTC IS DETECTED. FURTHER TESTING MAY BE REQUIRED. | - | - | - | - | - |
| U0121 | 127 | VDC CAN CIR2 | x | x | x | x | |
| U0401 | 120 | ECM CAN CIR1 | x | x | x | x | |
| U0402 | 122 | TCM CAN CIR1 | x | x | x | x | |
| U0415 | 126 | VDC CAN CIR1 | x | x | x | x | |
| U1000 | 100 | CAN COMM CIRCUIT | x | x | x | x | |
| U1010 | 110 | CONTROL UNIT (CAN) | x | x | x | x | |