Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect auto anti-dazzling inside mirror (integrated homelink transmitter) connector.
3. Check voltage between auto anti-dazzling inside mirror (integrated homelink transmitter) harness connector and ground.
   TERMINALS VOLTAGE REFERENCE CHART
   
   

   (+)		(-)	Condition		Voltage (V) (Approx.)
   Auto anti-dazzling inside mirror (Integrated homelink transmitter)
   Connector	Terminal
   R6	10	Ground	Ignition switch position	OFF	Battery voltage
   				ON

   Is the inspection result normal? 

   YES: GO TO 2.

   NO-1: Check 10A fuse [No. 6 located in the fuse block (J/B)].

   NO-2: Harness for open or short between fuse and auto anti-dazzling inside mirror (integrated homelink transmitter).

Check continuity between auto anti-dazzling inside mirror (integrated homelink transmitter) harness connector and ground.

Is the inspection result normal? 

YES: GO TO 3.

NO: Repair or replace harness.

Refer to "INTERMITTENT INCIDENT ".

INSPECTION END