Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect auto anti-dazzling inside mirror (homelink universal transceiver) connector.
3. Check voltage between auto anti-dazzling inside mirror (home link universal transceiver) harness connector and ground.
   VOLTAGE REFERENCE CHART
   
   

   Auto anti-dazzling inside mirror (Homelink universal transceiver) connector	Terminal		Condition	Voltage (V) (Approx.)
   R3	10	Ground	Ignition switch position: OFF	Battery voltage
   	6		Ignition switch position: ON

   Is the inspection result normal? 

   YES: GO TO 2.

   NO: Check the following items.

   • 10A fuse [No. 3 located in the fuse block (J/B)]
   • 10A fuse [No. 6 located in the fuse block (J/B)]
   • Harness for open or short between fuse and auto anti-dazzling inside mirror (homelink universal transceiver).

Check continuity between auto anti-dazzling inside mirror (homelink universal transceiver) harness connector and ground.

Is the inspection result normal? 

YES: GO TO 3.

NO: Repair harness.

Refer to "INTERMITTENT INCIDENT ".

INSPECTION END