Removal and Installation: Removal

Remove the side lids (LH/RH).
Remove the driver air bag module mounting TORX bolt (LH/RH) with TORX bit (A).

Fig 1: Removing Driver Air Bag Module Mounting Torx Bolt Using Torx Bit
Courtesy of NISSAN MOTOR CO., U.S.A.
Pull out the driver air bag module assembly.
Disconnect the driver air bag module harness connector.
CAUTION:
- For installing/removing the driver air bag module harness connector, insert thin screwdriver wrapped in tape into notch, lift lock and remove connector.
- Install connector with lock raised, and push lock into connector.
- After installing the connector, check that the lock is pushed securely into it.
Fig 2: Disconnecting Driver Air Bag Module Harness Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove the driver air bag module assembly.

CAUTION:

Always place the driver air bag module with pad side facing upward.

Fig 3: Identifying Driver Air Bag Module With Pad Side Facing Upward
Courtesy of NISSAN MOTOR CO., U.S.A.
Never impact the driver air bag module.
Replace the driver air bag module if it has been dropped or sustained an impact.

Fig 4: Caution For Driver Air Bag Module
Courtesy of NISSAN MOTOR CO., U.S.A.
Never insert any foreign objects (screwdriver, etc.) into the driver air bag module.
Never disassemble the driver air bag module.
Never expose the driver air bag module to temperatures exceeding 90°C (194°F).
Never allow oil, grease, detergent, or water to come in contact with the driver air bag module.