LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2011 >> FX35 RWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> SRS Airbag -- FX35/FX50 >> Removal And Installation >> Curtain Air Bag Module >> Removal and Installation >> Removal

Removal and Installation: Removal

  1. Remove the headlining. Refer to "REMOVAL AND INSTALLATION ".
  2. Remove the curtain air bag module harness connector.
    CAUTION:
    • For installing/removing the curtain air bag module harness connector, insert thin screwdriver wrapped in tape into notch, lift lock and remove connector.
    • Install the connector with lock raised, and push lock into the connector.
    • After installing the connector, check that the lock is pushed securely into it.
    Fig 1: Disconnecting Driver Air Bag Module Harness Connector
    G04887382Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Remove the fixing bolts, and then remove the curtain air bag module.
CAUTION:
  • Never impact the curtain air bag module.
  • Replace the curtain air bag module if it has been dropped or sustained an impact.
    Fig 2: Caution For Air Bag Module
    G05224522Courtesy of NISSAN MOTOR CO., U.S.A.
  • Never insert any foreign objects (screwdriver, etc.) into the curtain air bag module.
  • Never disassemble the curtain air bag module.
  • Never expose the curtain air bag module to temperatures exceeding 90°C (194°F).
  • Never allow oil, grease, detergent, or water to come in contact with the curtain air bag module.
scientia non olet · About LEMON Manuals