Component Inspection
- CHECK EXHAUST VALVE TIMING CONTROL MAGNET RETARDER
- Turn ignition switch OFF.
- Disconnect exhaust valve timing control magnet retarder harness connector. Refer to "COMPONENT PARTS LOCATION ".
- Check resistance between exhaust valve timing control magnet retarder terminals as follows.
TERMINAL RESISTANCE REFERENCE CHARTTerminals Resistance 1 and 2 9.0 - 11.0 Ω [at 20°C (68°F)] Is the inspection result normal?
YES: INSPECTION END
NO: GO TO 2.
- REPLACE EXHAUST VALVE TIMING CONTROL MAGNET RETARDER
- Replace malfunctioning exhaust valve timing control magnet retarder.
- Perform "EXHAUST VALVE TIMING CONTROL LEARNING: SPECIAL REPAIR REQUIREMENT ".
INSPECTION END