Component Inspection

REPLACE INTELLIGENT KEY BATTERY
1. Release the lock knob at the back of the Intelligent Key and remove the mechanical key.
2. Insert a flat-bladed screwdriver (A) wrapped in a cloth into the slit of the corner and twist it to separate the upper part from the lower part.
  CAUTION:
  - Never touch the circuit board or battery terminal.
  - The key fob is water-resistant. However, if it does get wet, immediately wipe it dry.
    
    Fig 1: Inserting Flat-Blade Screwdriver Into Slit Of Corner
    Courtesy of NISSAN MOTOR CO., U.S.A.
3. Replace the battery with new one.
4. Align the tips of the upper and lower parts, and then push them together until it is securely closed.
  CAUTION:
  - When replacing battery, keep dirt, grease, and other foreign matter off the electrode contact area.
  - After replacing the battery, check that all Intelligent Key functions work normally.
  Is the inspection result normal?
  
  YES: Intelligent Key is OK.
  
  NO: Check remote keyless entry receiver. Refer to "COMPONENT FUNCTION CHECK ".
  
  Fig 2: Aligning Tips Of Key Battery Upper And Lower Parts
  Courtesy of NISSAN MOTOR CO., U.S.A.