LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2011 >> FX35 RWD >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Exterior Lighting System -- FX35/FX50 >> Periodic Maintenance >> Front Fog Lamp Aiming Adjustment >> Aiming Adjustment Procedure

Aiming Adjustment Procedure

  1. Place the screen.
    NOTE:
    • Stop the vehicle facing the wall.
    • Place the board on a plain road vertically.
  2. Face the vehicle with the screen. Maintain 10 m (32.8 ft) between the front fog lamp center and the screen.
  3. Start the engine. Turn the front fog lamp ON.
    NOTE: Shut off the front fog lamp light with the board to prevent from illuminating the adjustment screen.
    CAUTION: Never cover the lens surface with a tape etc. The lens is made of resin.
  4. Adjust the cutoff line height (A) with the aiming adjustment screw so that the distance (X) between the horizontal center line of front fog lamp (H) and (A) becomes 200 mm (7.87 in).

    Front fog lamp light distribution on the screen

    Fig 1: Checking Distance Between Horizontal Center Line Of Front Fog Lamp
    G07229447Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals