Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect malfunctioning door switch connector.
3. Check signal between malfunctioning door switch harness connector and ground using an oscilloscope.
   SIGNAL REFERENCE CHART
   
   

   (+)			(-)	Signal (Reference value)
   Door switch
   Connector		Terminal
   Driver side	B16	2	Ground
   Passenger side	B216	2
   Rear LH	B23	2
   Rear RH	B223	2
   Back door	D122	7		Battery voltage

   Is the inspection result normal? 

   YES-1: Back door: GO TO  3.

   YES-2: Other doors: GO TO  4.

   NO: GO TO 2.

1. Disconnect BCM connector.
2. Check continuity between BCM harness connector and door switch harness connector.
   CONTINUITY REFERENCE CHART
   
   

   BCM		Door switch		Continuity
   Connector	Terminal	Connector	Terminal
   M123	150	B16 (Driver side)	2	Existed
   	124	B216 (Passenger side)
   M121	69	B23 (Rear LH)
   	68	B223 (Rear RH)
   	66	D122 (Back door)	7

3. Check continuity between BCM harness connector and ground.
   CONTINUITY REFERENCE CHART
   
   

   BCM		Ground	Continuity
   Connector	Terminal
   M123	150 (Driver side)		Not existed
   	124 (Passenger side)
   M121	69 (Rear LH)
   	68 (Rear RH)
   	66 (Back door)

   Is the inspection result normal? 

   YES: Replace BCM. Refer to "REMOVAL AND INSTALLATION ".

   NO: Repair or replace harness.

Check continuity between back door lock assembly (back door switch) harness connector and ground.

Is the inspection result normal? 

YES: GO TO 4.

NO: Repair or replace harness.

Refer to "COMPONENT INSPECTION ".

Is the inspection result normal? 

YES: GO TO 5.

NO: Replace malfunctioning door switch.

• Door switch: Refer to "REMOVAL AND INSTALLATION ".
• Back door lock assembly (back door switch): Refer to "REMOVAL AND INSTALLATION ".

Refer to "INTERMITTENT INCIDENT ".

INSPECTION END