Repair The Cause

• If the cause is a loose component, tighten the component securely.
• If the cause is insufficient clearance between components:
  • Separate components by repositioning or loosening and retightening the component, if possible.
  • Insulate components with a suitable insulator such as urethane pads, foam blocks, felt cloth tape or urethane tape. A Nissan Squeak and Rattle Kit (J-43980) is available through the authorized Nissan Parts Department.

The following materials are contained in the Nissan Squeak and Rattle Kit (J-43980). Each item can be ordered separately as needed.

URETHANE PADS [1.5 mm (0.059 in) thick]

Insulates connectors, harness, etc.

• 76268-9E005: 100 x 135 mm (3.937 x 5.315 in)
• 76884-71L01: 60 x 85 mm (2.362 x 3.346 in)
• 76884-71L02:15 x 25 mm (0.591 x 0.984 in)

INSULATOR (Foam blocks)

Insulates components from contact. Can be used to fill space behind a panel.

• 73982-9E000: 45 mm (1.772 in) thick, 50 x 50 mm (1.969 x 1.969 in)
• 73982-50Y00: 10 mm (0.394 in) thick, 50 x 50 mm (1.969 x 1.969 in)

INSULATOR (Light foam block)

80845-71L00: 30 mm (1.18 in) thick, 30 x 50 mm (1.181 x 1.969 in)

FELT CLOTHTAPE

Used to insulate where movement does not occur. Ideal for instrument panel applications.

• 68370-4B000: 15 x 25 mm (0.591 x 0.984 in) pad
• 68239-13E00: 5 mm (0.197 in) wide tape roll

The following materials, not found in the kit, can also be used to repair squeaks and rattles.

UHMW (TEFLON) TAPE

Insulates where slight movement is present. Ideal for instrument panel applications.

SILICONE GREASE

Used in place of UHMW tape that is be visible or does not fit. Will only last a few months.

SILICONE SPRAY

Used when grease cannot be applied.

DUCT TAPE

Used to eliminate movement.