Diagnosis Procedure
- CHECK GROUND CONNECTION
- Turn ignition switch OFF.
- Check ground connection M95. Refer to Ground Inspection in
CIRCUIT INSPECTION
.
Is the inspection result normal?
YES: GO TO 2.
NO: Repair or replace ground connection.
- CHECK THROTTLE POSITION SENSOR 2 POWER SUPPLY CIRCUIT-I
- Disconnect electric throttle control actuator harness connector.
- Turn ignition switch ON.
- Check the voltage between electric throttle control actuator harness connector and ground.VOLTAGE REFERENCE TABLE
DTC Electric throttle control actuator Ground Voltage (V) Bank Connector Terminal P0122, P0123 1 F66 2 Ground Approx. 5 P0227, P0228 2 F64 2 Is the inspection result normal?
YES: GO TO 3.
NO: Repair open circuit, short to ground or short to power in harness or connectors.
- CHECK THROTTLE POSITION SENSOR 2 GROUND CIRCUIT FOR OPEN AND SHORT
- Turn ignition switch OFF.
- Disconnect ECM harness connector.
- Check the continuity between electric throttle control actuator harness connector and ECM harness connector.CONTINUITY REFERENCE TABLE
DTC Electric throttle control actuator ECM Continuity Bank Connector Terminal Connector Terminal P0122, P0123 1 F66 4 F111 71 Existed P0227, P0228 2 F64 4 72 - Also check harness for short to ground and short to power.
Is the inspection result normal?
YES: GO TO 4.
NO: Repair open circuit, short to ground or short to power in harness or connectors.
- CHECK THROTTLE POSITION SENSOR 2 INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT
- Check the continuity between electric throttle control actuator harness connector and ECM harness connector.CONTINUITY REFERENCE TABLE
DTC Electric throttle control actuator ECM Continuity Bank Connector Terminal Connector Terminal P0122, P0123 1 F66 3 F111 78 Existed P0227, P0228 2 F64 3 74 - Also check harness for short to ground and short to power.
Is the inspection result normal?
YES: GO TO 5.
NO: Repair open circuit, short to ground or short to power in harness or connectors.
- Check the continuity between electric throttle control actuator harness connector and ECM harness connector.
- CHECK THROTTLE POSITION SENSOR
Refer to COMPONENT INSPECTION .
Is the inspection result normal?
YES: GO TO 7.
NO: GO TO 6.
- REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
- Replace malfunctioning electric throttle control actuator.
- Perform
THROTTLE VALVE CLOSED POSITION LEARNING: SPECIAL REPAIR REQUIREMENT
.
INSPECTION END
- CHECK INTERMITTENT INCIDENT
Refer to INTERMITTENT INCIDENT .
INSPECTION END