LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2010 >> EX35 Base, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter, Warning Lamp & Indicator >> Component Diagnosis >> Meter Control Switch Signal Circuit >> Diagnosis Procedure

Diagnosis Procedure

  1. CHECK METER CONTROL SWITCH INPUT SIGNAL
    1. Turn ignition switch ON.
    2. Measure voltage between the following terminals of the combination meter.
      VOLTAGE REFERENCE CHART

      Combination meter Condition Voltage (Approx.)
      Connector Terminal
      (+) (-)
      M53 36 16 When • (select) switch is pressed 0 V
      Other than the above 5 V
      37 16 When □ (enter) switch is pressed 0 V
      Other than the above 5 V
      39 16 When (-) (illumination control) switch is pressed 0 V
      Other than the above 5 V
      40 16 When (+) (illumination control) switch is pressed 0 V
      Other than the above 5 V

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: GO TO 2.

  2. CHECK METER CONTROL SWITCH SIGNAL CIRCUIT
    1. Turn ignition switch OFF.
    2. Disconnect the combination meter and meter control switch connectors.
    3. Check continuity between combination meter harness connector and meter control switch harness connector.
      CONTINUITY REFERENCE CHART

      Combination meter Meter control switch Continuity
      Connector Terminal Connector Terminal
      M53 16 M54 2 Existed
      36 6
      37 7
      39 3
      40 1
    4. Check continuity between combination meter harness connector and ground.
      CONTINUITY REFERENCE CHART

      Combination meter Ground Continuity
      Connector Terminal
      M53 16 Not existed
      36
      37
      39
      40

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: Repair harness or connector.

scientia non olet · About LEMON Manuals