LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2009 >> FX35 AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter, Warning Lamp & Indicator >> Component Diagnosis >> Power Supply And Ground Circuit >> Combination Meter >> COMBINATION METER : Diagnosis Procedure

COMBINATION METER : Diagnosis Procedure

  1. CHECK FUSE

    Check for blown fuses.

    FUSE SPECIFICATION

    Power source Fuse No.
    Battery 11
    Ignition switch ON or START 4

    Is the inspection result normal? 

    YES: GO TO 2.

    NO: Be sure to eliminate cause of malfunction before installing new fuse.

  2. CHECK POWER SUPPLY CIRCUIT

    Check voltage between combination meter harness connector and ground.

    TERMINAL VOLTAGE REFERENCE

    Terminals Ignition switch position Value (Approx.)
    (+) (-)
    Combination meter Terminal Signal name
    M53 1 Battery power supply Ground OFF Battery voltage
    21 Ignition signal ON Battery voltage

    Is the inspection result normal? 

    YES: GO TO 3.

    NO: Check harness between combination meter and fuse.

  3. CHECK GROUND CIRCUIT
    1. Turn ignition switch OFF.
    2. Disconnect combination meter connector.
    3. Check continuity between combination meter harness connector and ground.
      TERMINAL CONTINUITY REFERENCE

      Combination meter Ground Continuity
      Connector Terminal
      M53 5 Existed
      15 Existed
      22 Existed

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: Repair harness or connector.

scientia non olet · About LEMON Manuals