LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2009 >> FX35 AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter, Warning Lamp & Indicator >> Component Diagnosis >> Parking Brake Switch Signal Circuit >> Diagnosis Procedure

Diagnosis Procedure

  1. CHECK COMBINATION METER INPUT SIGNAL
    1. Turn ignition switch ON.
    2. Check the voltage and waveform between combination meter harness connector and ground.
      TERMINAL VOLTAGE REFERENCE

      Terminals Condition Voltage and waveform
      (+) (-)
      Combination meter Ground
      Connector Terminal
      M53 27 Parking brake applied Approx. 0 V
      Parking brake released
      G05223673Courtesy of NISSAN DIESEL MOTOR CO., LTD.

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: GO TO 2.

  2. CHECK PARKING BRAKE SWITCH SIGNAL CIRCUIT
    1. Turn ignition switch OFF.
    2. Disconnect combination meter connector and parking brake switch connector.
    3. Check continuity between combination meter harness connector and parking brake switch harness connector.
      TERMINAL CONTINUITY REFERENCE

      Combination meter Parking brake switch Continuity
      Connector Terminal Connector Terminal
      M53 27 E107 1 Existed
    4. Check continuity between combination meter harness connector and ground.
      TERMINAL CONTINUITY REFERENCE

      Combination meter Ground Continuity
      Connector Terminal
      M53 27 Not existed

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: Repair harness or connector.

scientia non olet · About LEMON Manuals