Removal and Installation: Removal

Put selector lever in drive position.
Remove selector lever knob.
- Refer to "2WD : Removal And Installation ". (2WD models)
- Refer to "AWD : Removal And Installation ". (AWD models)
Remove console finisher assembly.
- Pull console finisher (1), upward to disengage from center console.
- Disconnect harness connectors.
  
  Fig 1: Pulling Console Finisher
  Courtesy of NISSAN MOTOR CO., U.S.A.
Disconnect console sub harness connectors (A).
Remove center console fixing screws (B).

Fig 2: Identifying Console Sub Harness Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Put front seat to front must position.
Remove console rear finisher.
- Pull back the console rear finisher (1) with remover tool (A).
- Disconnect inside key antenna connector.
  
  Fig 3: Pulling Back Rear Console Finisher
  Courtesy of NISSAN MOTOR CO., U.S.A.
Remove rear ventilator duct (1).
Refer to "Rear Ventilator Duct 2 : Removal And Installation ".
Remove center console fixing screws (A).

Fig 4: Identifying Rear Ventilator Duct
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove center console assembly.
- Lift up center console assembly back side.
- Disconnect harness connectors.