CLUSTER LID C : Removal and Installation: Removal

Remove cup holder.
- Pull up to remove cup holder.
  
  Fig 1: Removing Cup Holder
  Courtesy of NISSAN MOTOR CO., U.S.A.
Remove switch finisher.
- Remove switch finisher fixing screws.
- Disconnect harness connector.
Remove A/T console finisher.
- Place the selector lever in "D" position.
- Remove selector lever knob. Refer to "CONTROL DEVICE REMOVAL AND INSTALLATION ".
- Lift up backside and pull back.
- Disconnect harness connector.
  
  Fig 2: Removing A/T Console Finisher
  Courtesy of NISSAN MOTOR CO., U.S.A.
Remove cluster lid C.
- Remove cluster lid C fixing screws.
- Pull back.
- Disconnect harness connector.
  
  Fig 3: Removing Cluster Lid C
  Courtesy of NISSAN MOTOR CO., U.S.A.