Diagnosis Procedure (M/T models)

1. Turn ignition switch ON.
2. Check the voltage and waveform between combination meter harness connector terminal and ground.

Terminals			Condition	Voltage (Approx.)
(+)		(-)
Combination meter
Connector	Terminal
M53	27	Ground	Parking brake applied	0 V
			Parking brake released	Courtesy of NISSAN MOTOR CO., U.S.A.

Is the inspection result normal? 

YES: INSPECTION END

NO: GO TO  2.

1. Turn ignition switch OFF.
2. Disconnect combination meter connector and parking brake switch connector.
3. Check continuity between combination meter harness connector terminal and parking brake switch harness connector terminal.
   CONNECTOR TERMINAL CONTINUITY CHART
   
   

   Combination meter		Parking brake switch		Continuity
   Connector	Terminal	Connector	Terminal
   M53	27	B14	1	Existed

4. Check continuity between combination meter harness connector terminal and ground.

Is the inspection result normal? 

YES: INSPECTION END

NO: Repair harness or connector.