Component Inspection

REMOVE FUEL LEVEL SENSOR UNIT
Remove the fuel level sensor unit. Refer to "REMOVAL AND INSTALLATION ".

GO TO 2.

CHECK FUEL LEVEL SENSOR UNIT AND FUEL PUMP (MAIN)

Check the resistance between fuel level sensor unit and fuel pump (main).

TERMINAL RESISTANCE CHART

Terminal		Float position	Resistance value (Ω)
2	5	Full (A)	Approx. 3
2	5	Empty (B)	Approx. 80

Fig 1: Checking Resistance Between Fuel Level Sensor Unit And Fuel Pump (Main)

Courtesy of NISSAN MOTOR CO., U.S.A.

Standard float position

STANDARD FLOAT POSITION

Float position [mm (in)]
Full	Approx. 210 (8.27)
Empty	Approx. 30 (1.18)

Is the inspection result OK?

YES: GO TO 3.

NO: Replace fuel level sensor unit and fuel pump (main).

CHECK FUEL LEVEL SENSOR UNIT (SUB)

Inspect the resistance of fuel level sensor unit (sub).

TERMINAL RESISTANCE CHART

Terminal		Float position	Resistance value (Ω)
1	2	Full (A)	Approx. 3
1	2	Empty (B)	Approx. 43

Fig 2: Checking Resistance Of Fuel Level Sensor Unit (SUB)

Courtesy of NISSAN MOTOR CO., U.S.A.

Standard float position

STANDARD FLOAT POSITION

Float position [mm (in)]
Full	Approx. 9 (0.35)
Empty	Approx. 179 (7.05)

Is the inspection result OK?

YES: INSPECTION END

NO: Replace fuel level sensor unit (sub).