Diagnosis Procedure

1. Turn ignition switch OFF.
2. Check voltage between BCM harness connector and ground.

Terminals				Door request switch Condition	Voltage (V) (Approx.)
(+)			(-)
BCM connector		Terminal
M122	Door request switch (driver side)	101	Ground	Pressed	0
				Released	Courtesy of NISSAN MOTOR CO., U.S.A.
	Door request switch (passenger side)	100		Pressed	0
				Released	Courtesy of NISSAN MOTOR CO., U.S.A.

Is the inspection result normal? 

YES: GO TO  6.

NO: GO TO  2.

1. Disconnect BCM and front outside handle connector.
2. Check continuity between BCM connector and front outside handle connector.
   CONTINUITY SPECIFICATION
   
   

   BCM connector	Terminal	Front outside handle connector	Terminal	Continuity
   M122	101	D13 (driver side)	1	Existed
   	100	D43 (passenger side)

3. Check continuity between BCM connector and ground.

Is the inspection result normal? 

YES: GO TO  3.

NO: Repair or replace harness between BCM and front outside handle.

Check continuity between front outside handle connector and ground.

Is the inspection result normal? 

YES: GO TO  4.

NO: Repair or replace front outside handle ground circuit.

1. Connect BCM connector.
2. Check voltage between BCM connector and ground.

Terminals			Voltage (V) (Approx.)
(+)		(-)
BCM connector	Terminal
M122	101	Ground	Courtesy of NISSAN MOTOR CO., U.S.A.
	100

Is the inspection result normal? 

YES: GO TO  5.

NO: Replace BCM. refer to REMOVAL AND INSTALLATION .

Refer to "COMPONENT INSPECTION ".

Is the inspection result normal? 

YES: GO TO  6.

NO: Replace malfunctioning front outside handle. Refer to "FRONT DOOR LOCK : REMOVAL AND INSTALLATION ".

refer to INTERMITTENT INCIDENT .

INSPECTION END