Diagnosis Procedure

1. Start engine.
2. Check the operation of the parking brake warning lamp when operating the parking brake.
   WARNING LAMP STATUS
   
   

   Condition	Warning lamp status
   Parking brake ON	ON
   Parking brake OFF	OFF

Is the inspection result normal? 

YES: Replace combination meter.

NO: GO TO 2.

1. Turn ignition switch OFF.
2. Perform an inspection for the parking brake switch signal circuit. Refer to , "DIAGNOSIS PROCEDURE (A/T MODEL) ".

Is the inspection result normal? 

YES: GO TO 3.

NG : Repair harness or connector.

Perform a unit inspection for the parking brake switch. Refer to "COMPONENT INSPECTION ".

Is the inspection result normal? 

YES: Replace combination meter.

NO: Replace parking brake switch.