Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect IPDM E/R connector and oil pressure switch connector.
3. Check continuity between IPDM E/R harness connector E6 terminal 75 and oil pressure switch harness connector F37 terminal 1.

   75 - 1 : Continuity should exist.

4. Check continuity between IPDM E/R harness connector E6 terminal 75 and ground.

   75 - Ground : Continuity should not exist.

Is the inspection result normal? 

YES: INSPECTION END

NO: Repair harness or connector.