Component Inspection

1. Turn the ignition switch OFF.
2. Disconnect the meter control switch connector.
3. Check continuity of the meter control switch.
   CONTINUITY REFERENCE
   
   

   Connector	Terminal No.		Operation and status	Continuity
   M54	2	7	Press ◦ switch	Yes
   			Other than the above	No
   	1	7	Press □ switch	Yes
   			Other than the above	No
   	5	7	Press the trip A/B reset switch.	Yes
   			Other than the above	No
   	10	7	Press - switch	Yes
   			Other than the above	No
   	9	7	Press + switch	Yes
   			Other than the above	No

Is inspection result OK? 

YES: INSPECTION END

NO: Replace the meter control switch.