Wiper Dial Position Setting
COMBINATION SWITCH OPERATION CHART
| Wiper intermittent dial position | Intermittent operation interval | Combination switch | ||
|---|---|---|---|---|
| INT VOLUME 1 | INT VOLUME 2 | INT VOLUME 3 | ||
| 1 | Short ↓ ↑ Long |
ON | ON | ON |
| 2 | ON | ON | OFF | |
| 3 | ON | OFF | OFF | |
| 4 | OFF | OFF | OFF | |
| 5 | OFF | OFF | ON | |
| 6 | OFF | ON | ON | |
| 7 | OFF | ON | OFF | |
Example: For wiper intermittent dial position 1
Using combination switch reading function, BCM detects ON/OFF status of INT VOLUME 1, 2, and 3. When combination switch status is as listed below, BCM determines that it is wiper intermittent dial position 1.
- INT VOLUME 1: ON (Continuity exists between combination switch output 3 and input 1.)
- INT VOLUME 2: ON (Continuity exists between combination switch output 5 and input 1.)
- INT VOLUME 3: ON (Continuity exists between combination switch output 4 and input 2.)
BCM determines front wiper intermittent operation delay interval from wiper intermittent dial position 1 and vehicle speed, and sends wiper request signal (INT) to IPDM E/R.