Removal and Installation of Front and Rear Washer Pump: Removal

1. Remove fillet molding (RH). Refer to "FRONT BUMPER ".
2. Remove fender protector (RH). Refer to "FENDER PROTECTOR ".
3. Remove bumper fascia assembly. Refer to "FRONT BUMPER ".
4. Disconnect washer pump connector and tube.
5. Pull out front and rear washer pump in direction shown by the arrow in the figure. Remove front and rear washer pump from washer tank.

Fig 1: Locating Front And Rear Washer Pump

Courtesy of NISSAN MOTOR CO., U.S.A.