Check Power Supply And Ground Circuit
- CHECK FUSES
Check for blown fuses.
FUSES REFERENCE CHARTUnit Power source Fuse and fusible link No. BCM Battery M 22 Ignition ON or START 1 Front and rear washer pump Ignition ON or START 84 Refer to "WIRING DIAGRAM - WIP/R - ".
OK or NG
OK: GO TO 2.
NG: If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse, Refer to "POWER SUPPLY ROUTING CIRCUIT ".
- CHECK POWER SUPPLY CIRCUIT
- Turn ignition switch OFF.
- Disconnect BCM connector.
- Check voltage between BCM harness connector and ground.
POWER SUPPLY CIRCUIT(+) (-) Ignition switch position BCM connector Terminal OFF ON M3 38 Ground Approx. 0 V Battery voltage M4 42 Battery voltage Battery voltage 55 Battery voltage Battery voltage OK or NG
OK: GO TO 3.
NG: Repair harness or connector.
- CHECK GROUND CIRCUIT
Check continuity between BCM harness connector and ground.
Courtesy of NISSAN MOTOR CO., U.S.A.
GROUND CIRCUITBCM connector Terminal Ground Continuity M4 49 Yes 52 OK or NG
OK: INSPECTION END
NG: Repair harness or connector.