Component Inspection

1. Turn the ignition switch OFF.
2. Disconnect the meter control switch connector.
3. Check continuity between the following terminals of the meter control switch.
   TERMINALS CONTINUITY TABLE
   
   

   Combination meter			Operation and status	Continuity
   Connector	Terminal
   M54	6	2	Press • (select) switch	Existed
   			Other than the above	Not existed
   	7	2	Press enter switch	Existed
   			Other than the above	Not existed
   	3	2	Press - illumination control switch	Existed
   			Other than the above	Not existed
   	1	2	Press + illumination control switch	Existed
   			Other than the above	Not existed

Is inspection result normal? 

YES: INSPECTION END

NO: Replace the meter control switch.