LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2008 >> EX35 Base, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel >> On-Vehicle Repair >> Center Console Assembly >> Removal and Installation >> Removal

Removal and Installation: Removal

  1. Put selector lever in drive position.
  2. Remove selector lever knob.
  3. Remove console finisher assembly.
    • Pull console finisher (1), upward to disengage from center console.
      Fig 1: Identifying Console Finisher
      G05729918Courtesy of NISSAN MOTOR CO., U.S.A.
    • Disconnect harness connectors.
  4. Disconnect console sub harness connectors (A).
  5. Remove center console fixing screws (B).
    Fig 2: Identifying Center Console Fixing Screws
    G05729890Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Put front seat to front must position.
  7. Remove console rear finisher.
    • Pull back the console rear finisher (1) with remover tool (A).
      Fig 3: Identifying Back Console Rear Finisher
      G05729920Courtesy of NISSAN MOTOR CO., U.S.A.
    • Disconnect inside key antenna connector.
  8. Remove rear ventilator duct (1).

    Refer to REMOVAL AND INSTALLATION .

    Fig 4: Identifying Rear Ventilator Duct
    G05729892Courtesy of NISSAN MOTOR CO., U.S.A.
  9. Remove center console fixing screws (A).
  10. Remove center console assembly.
    • Lift up center console assembly back side.
    • Disconnect harness connectors.
scientia non olet · About LEMON Manuals