Terminals and Reference Values for BCM
CAUTION:
- Check combination switch system terminal waveform under the loaded condition with lighting switch, turn signal switch and wiper switch OFF not to be fluctuated by overloaded.
- Turn wiper intermittent dial position to 4 except when checking waveform or voltage of wiper intermittent dial position. Wiper intermittent dial position can be confirmed on CONSULT-II. Refer to "DATA MONITOR ".
VOLTAGE REFERENCE
| Terminal No. | Wire color | Signal name | Measuring condition | Reference value | ||
|---|---|---|---|---|---|---|
| Ignition switch | Operation or condition | |||||
| 5 | Y/R | Combination switch input 2 | ON | Lighting, turn, wiper switch (Wiper intermittent dial position 4) | OFF | Approx. 0 V |
| Rear washer switch | ||||||
| Rear wiper switch ON | ||||||
| 6 | SB | Combination switch input 1 | ON | Lighting, turn, wiper switch (Wiper intermittent dial position 4) | OFF | Approx. 0 V |
| Rear wiper INT | ||||||
| 32 | GY/R | Combination switch output 5 | ON | Lighting, turn, wiper switch (Wiper intermittent dial position 4) | OFF | |
| Rear wiper ON | ||||||
| 33 | G | Combination switch output 4 | ON | Lighting, turn, wiper switch (Wiper intermittent dial position 4) | OFF | |
| Rear wiper switch INT | ||||||
| 34 | W/B | Combination switch output 3 | ON | Lighting, turn, wiper switch (Wiper intermittent dial position 4) | OFF | |
| Rear washer switch | ||||||
| 38 | W/L | Ignition switch (ON) | ON | - | Battery voltage | |
| 39 | L | CAN - H | - | - | - | |
| 40 | P | CAN - L | - | - | - | |
| 42 | L/R | Battery power supply | OFF | - | Battery voltage | |
| 49 | B | Ground | ON | - | Approx. 0 V | |
| 52 | B | Ground | ON | - | Approx. 0 V | |
| 55 | G | Battery power supply | OFF | - | Battery voltage | |
| 59 | Y | Rear wiper auto stop signal | ON | Wiper operating | Approx. 0 V | |
| Wiper stopped | Battery voltage | |||||
| 70 | SB | Rear wiper motor output signal | ON | Wiper switch | OFF | Approx. 0 V |
| ON | Battery voltage | |||||