Wiper Does Not Wipe When Front Washer Operates

CHECK CIRCUIT BETWEEN COMBINATION SWITCH AND BCM
With CONSULT-II
1. Select "BCM" on CONSULT-II, and select "WIPER" on "SELECT TEST ITEM" screen.
2. Select "DATA MONITOR" on "SELECT DIAG MODE" screen. Make sure that "FR WASHER SW" turn ON-OFF according to front wiper switch operation.
  
  Fig 1: Identifying CONSULT-II Screen Tool Display - DATA MONITOR
  Courtesy of NISSAN MOTOR CO., U.S.A.
  
  Without CONSULT-II
  
  Refer to "COMBINATION SWITCH INSPECTION ".
OK or NG

OK: Replace BCM Refer to "REMOVAL AND INSTALLATION OF BCM ".

NG: Check combination switch (wiper switch). Refer to "COMBINATION SWITCH INSPECTION ".