LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2007 >> FX35 RWD >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Wiper, Washer & Horn >> Front Wiper And Washer System >> Removal and Installation of Washer Tank >> Removal

Removal and Installation of Washer Tank: Removal

  1. Remove bolt and pull out washer tank inlet out of washer tank.
    Fig 1: Locating Washer Tank Inlet Out Of Washer Tank
    G05222553Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Remove front fillet molding (RH). Refer to "FRONT BUMPER ".
  3. Remove fender protector front (RH). Refer to "FENDER PROTECTOR ".
  4. Remove front bumper fascia assembly. Refer to "FRONT BUMPER ".
  5. Disconnect washer pump connector and wash fluid level sensor connector.
  6. Remove washer tank mounting bolt and nuts.
    Fig 2: Identifying Washer Tank And Bolt
    G05222554Courtesy of NISSAN MOTOR CO., U.S.A.
  7. Remove washer tube, and remove washer tank from the vehicle.
    8. Fig 3: Identifying Washer Tank And Nut
    G05222555Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals