Front Wiper Intermittent Operation Switch Position Cannot Be Adjusted

CHECK CIRCUIT BETWEEN COMBINATION SWITCH AND BCM
With CONSULT-II

Select "BCM" on CONSULT-II, and select "WIPER" on "SELECT TEST ITEM" screen.
Select "DATA MONITOR" on "SELECT DIAG MODE" screen. Make sure that "INT VOLUME", changes in order form 1 to 7 according to wiper switch operation.

Fig 1: Identifying CONSULT-II Screen Tool Display - DATA MONITOR
Courtesy of NISSAN MOTOR CO., U.S.A.

Without CONSULT-II

Refer to "COMBINATION SWITCH INSPECTION ".

OK or NG

OK: Replace BCM. Refer to "REMOVAL AND INSTALLATION OF BCM ".

NG: Check combination switch (wiper switch). Refer to "COMBINATION SWITCH INSPECTION ".