Front Wiper Does Not Stop

1. CHECK CIRCUIT BETWEEN COMBINATION SWITCH AND BCM 

   With CONSULT-II

1. Select "BCM" on CONSULT-II, and select "WIPER" on "SELECT TEST ITEM" screen.
2. Select "DATA MONITOR" on "SELECT DIAG MODE" screen. Make sure that "FR WIPER INT", "FR WIPER LOW", "FR WIPER HI", and "FR WASHER SW" turn ON-OFF according to front wiper switch operation.
   Fig 1: Identifying CONSULT-II Screen Tool Display - DATA MONITOR

   Courtesy of NISSAN MOTOR CO., U.S.A.

   Without CONSULT-II

   Refer to "COMBINATION SWITCH INSPECTION ".

OK or NG 

OK: Replace IPDM E/R.

NG: Check combination switch (wiper switch). Refer to "COMBINATION SWITCH INSPECTION ".