Wiper Operation: Description

The front wiper switch is controlled by a lever built into the combination switch.

There are three wiper switch positions.

• LO speed
• HI speed
• INT (intermittent)

Power is supplied at all times

• through 10A fuse [No. 3, located in fuse block (J/B) No. 1]
• to BCM terminal 105.

With the ignition switch in the ON or START position, power is supplied

• through 20A fuse [No. 34, located in fuse block (J/B) No. 2]
• to front wiper motor terminal 4
• to front wiper relay terminal 1
• to front wiper rain relay terminal 1
• through 10A fuse [No. 1, located in fuse block (J/B) No. 1]
• to BCM terminal 68
• to rain sensor terminal 1
• through 10A fuse [No. 9, located in fuse block (J/B) No. 1]
• to combination meter terminal 59.

Ground is supplied

• to front wiper switch terminals 17 and 20
• through grounds M25 and M115.