Washer Operation
With the ignition switch in the ON or START position, power is supplied
- through 20A fuse [No. 34, located in fuse block (J/B) No. 2]
- to front washer pump terminal 1.
When the front wiper switch in the WASH position, ground is supplied
- to front washer pump terminal 2
- to BCM terminal 4
- from front wiper switch terminal 18
- through front wiper switch terminal 17
- through grounds M25 and M115.
With power and ground supplied, the front washer pump operates. The front wiper motor operates at low speed for about 3 seconds. This feature is controlled by the BCM in the same manner as the intermittent operation.