Consult-II Basic Operation

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which perform CAN communication.

With ignition switch OFF, connect "CONSULT-II" and "CONSULT-II CONVERTER" to data link connector, and turn ignition switch ON.

Fig 1: Connecting CONSULT II To Data Link Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Select "START (NISSAN BASED VHCL)".

Fig 2: Consult-II Display Screen
Courtesy of NISSAN MOTOR CO., U.S.A.
Select "IVMS".
If "IVMS" is not indicated, refer to "CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT ".

Fig 3: Consult-II SELECT SYSTEM Display Screen
Courtesy of NISSAN MOTOR CO., U.S.A.
Select "WITH SUNROOF" on "SELECT SYS COND" screen.
Touch "OK". If the selection is wrong, touch "CANCEL".

Fig 4: CONSULT II SYS COND Screen
Courtesy of NISSAN MOTOR CO., U.S.A.
Select the desired part to be diagnosed on "SELECT TEST ITEM" screen.