Front Wiper and Washer Activate Individually but Intermittent Wiper and Washer Combination Does Not Operate

CHECK POWER SUPPLY CIRCUIT FOR FRONT WIPER RELAY
1. Turn ignition switch OFF.
2. Remove front wiper relay.
3. Turn ignition switch ON.
4. Check voltage between front wiper relay harness connector E4 terminal 1 and ground.
  1 - Ground: Battery voltage
  
  Fig 1: Checking Voltage Between Front Wiper Relay Harness Connector E4 Terminal 1 And Ground
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
- OK: GO TO 2.
- NG: Check the following.
  - 20A fuse [No. 34, located in fuse block (J/B) No. 2]
  - Harness for open or short between front wiper relay and fuse
CHECK GROUND CIRCUIT FOR FRONT WIPER RELAY
1. Turn ignition switch OFF.
2. Check continuity between front wiper relay harness connector E4 terminal 5 and ground.
  5 - Ground: Continuity should exist.
  
  Fig 2: Checking Continuity Between Front Wiper Relay Harness Connector E4 Terminal 5 And Ground
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
- OK: GO TO 3.
- NG: Repair harness ground circuit.
CHECK FRONT WIPER RELAY
Apply battery voltage to between front wiper relay terminal 1 and 2, and check continuity between terminal 3 and 5.

3 - 5: Continuity should exist.

OK or NG
- OK: GO TO 4.
- NG: Replace front wiper relay.
  
  Fig 3: Checking Front Wiper Relay
  Courtesy of NISSAN MOTOR CO., U.S.A.
CHECK BCM OUTPUT SIGNAL
1. Connect front wiper relay.
2. Turn ignition switch ON.
3. Check voltage between BCM harness connector E204 terminal 128 and ground.
  When front wiper switch is: Approx. 0 V (for 0.7 sec.)
  
  WASH
  
  When front wiper switch is: Battery voltage
  
  OFF
  
  Fig 4: Checking Voltage Between BCM Harness Connector E204 Terminal 128 And Ground
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
- OK: Repair harness between front wiper relay and BCM.
- NG: Replace BCM.