Combination Meter Buzzer Circuit Inspection

1. Select "BUZZER" of "BCM" on CONSULT-II.
2. Perform "LIGHT WARN ALM""IGN KEY WARN ALM" or "SEAT BELT WARN TEST" of "ACTIVE TEST".

Does chime sound? 

YES : GO TO  4.

NO : GO TO 2.

Fig 1: Displaying Active Test

Courtesy of NISSAN MOTOR CO., U.S.A.

1. Select "METER A/C AMP" on CONSULT-II.
2. Operate switches to meet the requirements to sound warning chime with "BUZZER" of "DATA MONITOR" and check operation status.

   "BUZZER" 

   When meeting the requirements to sound warning chime : ON 

   Except above : OFF 

   Fig 2: Displaying Data Monitor

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK : GO TO 3.

NG : Replace BCM. Refer to "REMOVAL AND INSTALLATION OF BCM ".

Check battery power supply circuit of combination meter. Refer to "POWER SUPPLY AND GROUND CIRCUIT INSPECTION ".

OK or NG 

OK : Replace combination meter.

NG : Check harness between combination meter and fuse.

Check battery power supply circuit of unified meter and A/C amp. Refer to "POWER SUPPLY AND GROUND CIRCUIT INSPECTION ".

OK or NG 

OK : INSPECTION END

NG : Check harness between unified meter and A/C amp. and fuse.