LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2006 >> FX35 RWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Body, Lock & Security System >> IVIS (INFINITI Vehicle Immobilizer System-NATS) >> ECM Re-Communicating Function

ECM Re-Communicating Function

Performing following procedure can automatically perform re-communication of ECM and BCM or Intelligent Key unit, but only when the ECM has been replaced with a new one (*1).

*1: New one means a virgin ECM which has never been energized on-board.

(In this step, initialization procedure by CONSULT-II is not necessary)

NOTE:
  • When registering new Key IDs or replacing the ECM other than brand new.
  • If multiple keys are attached to the key holder, separate them before work.
  • Distinguish keys with unregistered key ID from those with registered ID.
  1. Install ECM.
  2. Using a registered key (*2), turn ignition switch to "ON".

    *2: To perform this step, use the key that has been used before performing ECM replacement.

  3. Maintain ignition switch in "ON" position for at least 5 seconds.
  4. Turn ignition switch to "OFF".
  5. Start engine.

    If engine can be started, procedure is completed.

    If engine cannot be started initialize control unit.

scientia non olet · About LEMON Manuals