Rear Wipers Do Not Stop

CHECK CIRCUIT BETWEEN COMBINATION SWITCH AND BCM
With CONSULT-II
1. Select "BCM" on CONSULT-II, and select "WIPER" on "SELECT TEST ITEM" screen.
2. Select "DATA MONITOR" on "SELECT DIAG MODE" screen. Make sure that "RR WIPER INT""RR WIPER ON", and "RR WASHER SW" turn ON-OFF according to wiper switch operation.
Without CONSULT-II

Refer to "COMBINATION SWITCH INSPECTION ".

OK or NG

OK : Replace BCM. Refer to "REMOVAL AND INSTALLATION OF BCM ".

NG : Check combination switch (wiper switch). Refer to "COMBINATION SWITCH INSPECTION ".

Fig 1: CONSULT-II Display - Data Monitor
Courtesy of NISSAN MOTOR CO., U.S.A.