Wiper Does Not Wipe When Front Washer Operates

CHECK CIRCUIT BETWEEN COMBINATION SWITCH AND BCM
With CONSULT-II
1. Select "BCM" on CONSULT-II, and select "WIPER" on "SELECT TEST ITEM" screen.
2. Select "DATA MONITOR" on "SELECT DIAG MODE" screen. Make sure that "FR WASHER SW" turn ON-OFF according to front wiper switch operation.
Without CONSULT-II

Refer to "COMBINATION SWITCH INSPECTION ".

OK or NG

OK : Replace BCM Refer to "REMOVAL AND INSTALLATION OF BCM ".

NG : Check combination switch (wiper switch). Refer to "COMBINATION SWITCH INSPECTION ".

Fig 1: CONSULT-II Display - Data Monitor
Courtesy of NISSAN MOTOR CO., U.S.A.