LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2006 >> FX35 RWD >> Repair and Diagnosis (Single Page) >> Electrical >> Horns >> Wiper, Washer & Horn >> Front Wiper And Washer System >> Removal and Installation of Front Wiper Drive Assembly >> Installation

Removal and Installation of Front Wiper Drive Assembly: Installation

  1. Install front wiper drive assembly to the vehicle.

    Front wiper drive assembly mounting bolt : 4.5 N.m (0.46 kg-m, 40 in-lb) 

  2. Connect wiper motor assembly to the connector. Turn wiper switch ON to operate wiper motor, then turn wiper switch OFF (auto stop).
  3. Attach washer tube to washer tube joint.
  4. Install cowl top cover. Refer to "COWL TOP ".
  5. Install wiper arms. Refer to "REMOVAL AND INSTALLATION OF FRONT WIPER ARMS, ADJUSTMENT OF WIPER ARMS STOP LOCATION ".
  6. Attach wiper arm washer tube.
    CAUTION:
    • Never drop the wiper motor or cause it to contact other parts.
    • Check grease conditions of the motor arm and wiper link joint (at retainer). Apply grease if necessary.
scientia non olet · About LEMON Manuals