Front Wiper Intermittent Operation Switch Position Cannot Be Adjusted

With CONSULT-II

1. Select "BCM" on CONSULT-II, and select "WIPER" on "SELECT TEST ITEM" screen.
2. Select "DATA MONITOR" on "SELECT DIAG MODE" screen. Make sure that "INT VOLUME", changes in order form 1 to 7 according to wiper switch operation.

Without CONSULT-II

Refer to "COMBINATION SWITCH INSPECTION ".

OK or NG 

OK : Replace BCM. Refer to "REMOVAL AND INSTALLATION OF BCM ".

NG : Check combination switch (wiper switch). Refer to "COMBINATION SWITCH INSPECTION ".

Fig 1: CONSULT-II Display - Data Monitor

Courtesy of NISSAN MOTOR CO., U.S.A.